Console Port Login Configuration With Authentication Mode Being Password - H3C S7500 Series Operation Manual

Operation Manual – Login
H3C S7500 Series Ethernet Switches
# Enter AUX user interface view.
[H3C] user-interface aux 0
# Specify not to authenticate users logging in through the console port.
[H3C-ui-aux0] authentication-mode none
# Specify commands of level 2 are available to users logging into the AUX user
interface.
[H3C-ui-aux0] user privilege level 2
# Set the baud rate of the console port to 19,200 bps.
[H3C-ui-aux0] speed 19200
# Set the maximum number of lines the screen can contain to 30.
[H3C-ui-aux0] screen-length 30
# Set the maximum number of commands the history command buffer can store to 20.
[H3C-ui-aux0] history-command max-size 20
# Set the timeout time of the AUX user interface to 6 minutes.
[H3C-ui-aux0] idle-timeout 6
2.5 Console Port Login Configuration with Authentication
Mode Being Password
2.5.1 Configuration Procedure
Follow these steps to perform console port login configuration with the authentication
mode being password:
To do...
Enter system view
Enter AUX user
interface view
Configure to
authenticate users
using the local
password
Set the local
password
Chapter 2 Logging in through the Console Port
Use the command...
system-view
user-interface aux 0
authentication-mode
password
set authentication
password { cipher |
simple } password
2-9
Remarks
—
—
Required
By default, users logging into a
switch through the console port
are not authenticated; while those
logging in through Modems or
Telnet are authenticated.
Required