H3C S7500 Series Operation Manual page 856

Operation Manual – FTP and TFTP
H3C S7500 Series Ethernet Switches
Connected to 1.1.1.1.
220 FTP service ready.
User (1.1.1.1:(none)): switch
331 Password required for switch.
Password:
230 User logged in.
ftp>
# Upload the switch.bin file.
ftp> put switch.bin
200 Port command okay.
150 Opening ASCII mode data connection for switch.bin.
226 Transfer complete.
# Download the config.cfg file.
ftp> get config.cfg
200 Port command okay.
150 Opening ASCII mode data connection for config.cfg.
226 Transfer complete.
ftp: 3980 bytes received in 8.277 seconds 0.48Kbytes/sec.
This example uses the command line window tool provided by Windows. When you log
into the FTP server through another FTP client, refer to the corresponding instructions
for operation description.
Caution:
If the available space of the flash of the switch is not enough to hold the file to be
uploaded, you need to delete the existing applications in the flash and then upload
new applications to the flash of the switch.
The H3C Series Switches are not loaded with FTP client applications. You need to
purchase and install them separately.
3) After uploading the application, you can update the application on the switch.
# Use the boot boot-loader command to specify the uploaded file (switch.bin) to be
the startup file used when the switch starts the next time, and restart the switch. Thus
the switch application is upgraded.
<H3C> boot boot-loader switch.bin
<H3C> reboot
Chapter 1 FTP and TFTP Configuration
1-6