Loading Software Using Ftp Through Ethernet Port - H3C S7500 Series Operation Manual

Operation Manual – System Maintenance and Debugging
H3C S7500 Series Ethernet Switches
Loading........................................done
Bootrom updating..........done!
III. Loading host software
Follow these steps to load the host software.
Step 1: Select <1> in Boot Menu and press <Enter>. The system displays the following
information:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):3
Step 2: Enter 1 in the above menu to download the host software using TFTP.
The subsequent steps are the same as those for loading the Boot ROM program,
except that the system gives the prompt for host software loading instead of Boot ROM
loading.
Caution:
When loading Boot ROM and host software using Boot menu, you are recommended to
use the PC directly connected to the device as TFTP server to promote upgrading
reliability.

1.2.4 Loading Software Using FTP through Ethernet Port

I. Introduction to FTP
FTP is an application-layer protocol in the TCP/IP protocol suite. It is used for file
transfer between server and client, and is widely used in IP networks.
You can use the switch as an FTP client or a server, and download software to the
switch through an Ethernet port. The following is an example.
II. Loading Process Using FTP Client
Loading Boot ROM software
Chapter 1 Boot ROM and Host Software
1-10
Loading