H3C S7500 Series Operation Manual page 308

Operation Manual – Routing Protocol
H3C S7500 Series Ethernet Switches
Enter system view
Enable RIP globally and
enter RIP view
Enable RIP on the
interface of a specified
network segment
Note:
If you make some RIP configurations in interface view before enabling RIP, those
configurations will take effect after RIP is enabled.
RIP runs only on the interfaces residing on the specified networks. Therefore, you
need specify the network after enabling RIP to validate RIP on a specific interface.
II. Set the RIP operating status on an interface
Follow these steps to set the RIP operating status on an interface:
Enter system view
Enter interface view
Enable an interface to receive
RIP routing updates
Enable the interface to send
RIP routing updates
Enable the interface to send
and receive RIP packets
III. Specify the RIP version on an interface
Follow these steps to specify the RIP version on an interface:
To do...
Enter system view
Enter interface view
To do...
system-view
rip
network network-address
To do...
Use the command...
system-view
interface interface-type
interface-number
Use the command...
Use the command...
system-view
interface interface-type
interface-number
rip input
rip output
rip work
3-4
Chapter 3 RIP Configuration
Remarks
—
—
Required
By default, RIP is disabled
on any interface.
Remarks
—
—
Optional
By default, all the
interfaces are
allowed to send
and receive RIP
packets.
Remarks
—
—