Displaying The Routing Table - H3C S7500 Series Operation Manual

Operation Manual – Routing Protocol
H3C S7500 Series Ethernet Switches
Note:
If the destination IP address and the mask of a route are both 0.0.0.0, the route is
the default route. Any packet for which the router fails to find a matching entry in
the routing table will be forwarded through the default route.
Do not configure the next hop address of a static route as the IP address of an
interface on the local switch.
The preference can be configured differently to implement flexible route
management policy.

2.3 Displaying the Routing Table

Display routing table
summary
Display routing table
details
Display the detailed
information of a specific
route
Display the routes in a
specified address range
Display the routes fount
after specified ACL
filtering
Display the routes found
after specified prefix list
filtering
Display the routes
discovered by a specified
protocol
Display the
tree-structured routing
table information
Display the statistics of
the routing table
To do...
display ip routing-table
display ip routing-table verbose
display ip routing-table
ip-address [ mask ]
[ longer-match ] [ verbose ]
display ip routing-table
ip-address1 mask1 ip-address2
mask2 [ verbose ]
display ip routing-table acl
acl-number [ verbose ]
display ip routing-table ip-prefix
ip-prefix-name [ verbose ]
display ip routing-table protocol
protocol [ inactive | verbose ]
display ip routing-table radix
display ip routing-table statistics
Chapter 2 Static Route Configuration
Use the command...
2-3
Remarks
Available in any
view