Chapter 5 Multicast Mac Address Entry Configuration; Overview; Configuring A Multicast Mac Address Entry - H3C S7500 Series Operation Manual

Operation Manual – Multicast
H3C S7500 Series Ethernet Switches
Chapter 5 Multicast MAC Address Entry

5.1 Overview

In Layer 2 multicast, the system can create multicast forwarding entries dynamically
through Layer 2 multicast protocol. However, you can also statically bind a port to a
multicast address entry by configuring a multicast MAC address entry manually.
Generally, when receiving a multicast packet whose multicast address has not yet been
registered on the switch, the switch will broadcast the packet in the VLAN to which the
port belongs. However, you can configure a static multicast MAC address entry to avoid
this case.

5.2 Configuring a Multicast MAC Address Entry

You can configure multicast MAC address entries in system view.
Follow these steps to configure a multicast MAC address entry in system view:
To do...
Enter system view
Create a multicast
MAC address entry
Configuration
Use the command...
system-view
mac-address multicast
mac-address interface
interface-list vlan vlan-id
5-1
Chapter 5 Multicast MAC Address Entry
Remarks
—
Required
The mac-address argument
must be a multicast MAC
address
The vlan-id argument is the ID
of the VLAN to which the port
belongs
Configuration