Pim Configuration Examples; Pim-Dm Configuration Example - H3C S7500 Series Operation Manual

Hide thumbs Also See for S7500 Series:

Table of Contents

Operation Manual – Multicast

H3C S7500 Series Ethernet Switches

7.6 PIM Configuration Examples

I. Network requirements

Lanswitch1 is connected to the multicast source through VLAN-interface 10, to

Lanswitch2 through VLAN-interface 11 and to Lanswitch3 through VLAN-interface 12.

Through PIM-DM, multicast is implemented among Receiver 1, Receiver 2 and the

multicast source.

II. Network diagram

Figure 7-7 Network diagram for PIM-DM configuratio

III. Configuration procedure

Only the configuration procedure on Lanswitch1 is listed. The configuration procedures

of Lanswitch2 and Lanswitch3 are similar to that of Lanswitch1.

# Enable the multicast routing protocol.

<H3C> system-view

[H3C] multicast routing-enable

# Enable IGMP and PIM-DM on the interfaces.

[H3C] vlan 10

[H3C-vlan10] port Ethernet 2/0/2 to Ethernet 2/0/3

[H3C-vlan10] quit

[H3C] vlan 11

[H3C-vlan11] port Ethernet 2/0/4 to Ethernet 2/0/5

[H3C-vlan11] quit

[H3C] vlan 12

[H3C-vlan12] port Ethernet 2/0/6 to Ethernet 2/0/7

[H3C-vlan12] quit

[H3C] interface Vlan-interface 10

[H3C-Vlan-interface10] ip address 1.1.1.1 255.255.0.0

[H3C-Vlan-interface10] igmp enable

[H3C-Vlan-interface10] pim dm

Chapter 7 PIM Configuration

Table of Contents