H3C S7500 Series Operation Manual page 872

Operation Manual – Information Center
H3C S7500 Series Ethernet Switches
To do...
Enter system view
Enable the
information center
Enable information
output to the console
Define an
information source
Set the format of
time stamp
To view debugging/log/trap output information on the console, you should also enable
the terminal display function for corresponding debugging/log/trap information on the
switch.
For example, to view log information of the switch on the console, you should not only
enable log information output to the console, but also enable log information terminal
display using the terminal logging command.
Perform the following operations to enable debugging/log/trap terminal display in user
view:
Enable the
debugging/log/trap
information terminal
display function
Enable the debugging
information terminal
display function
Enable the log information
terminal display function
Use the command...
system-view
info-center enable
info-center console channel
{ channel-number |
channel-name }
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
info-center timestamp { log |
trap | debugging } { boot |
date | none }
To do...
terminal monitor
terminal debugging
terminal logging
Use the
command...
Optional
By default, this function is
enabled for console users.
Optional
By default, the debugging
information terminal display is
disabled for terminal users.
Optional
By default, log information
terminal display is enabled for
console users.
1-8
Chapter 1 Information Center
Remarks
—
Optional
By default, the information
center is enabled.
Required
By default, the switch
uses information channel
0 to output
log/debugging/trap
information to the
console.
Required
Optional
Remarks