H3C S7500 Series Operation Manual page 790

Operation Manual – SNMP and RMON
H3C S7500 Series Ethernet Switches
II. Network diagram
10.10.10.1
NMS
Figure 1-2
III. Network procedure
# Set the community name, group name and user.
<H3C> system-view
[H3C] snmp-agent
[H3C] snmp-agent sys-info version all
[H3C] snmp-agent community write public
[H3C] snmp-agent mib-view include internet 1.3.6.1
[H3C] snmp-agent group v3 managev3group write-view internet
[H3C] snmp-agent usm-user v3 managev3user managev3group
# Set VLAN-interface 2 as the interface used by the NMS. Add Ethernet 2/0/2 to VLAN
2. This port will be used for network management. Set the IP address of VLAN-interface
2 as 10.10.10.2.
[H3C] vlan 2
[H3C-vlan2] port Ethernet 2/0/2
[H3C-vlan2] quit
[H3C] interface Vlan-interface 2
[H3C-Vlan-interface2] ip address 10.10.10.2 255.255.255.0
[H3C-Vlan-interface2] quit
# Enable the SNMP agent to send trap messages to the NMS whose IP address is
10.10.10.1. The SNMP community name is public.
[H3C] snmp-agent trap enable standard authentication
[H3C] snmp-agent trap enable standard coldstart
[H3C] snmp-agent trap enable standard linkup
[H3C] snmp-agent trap enable standard linkdown
[H3C] snmp-agent target-host trap address udp-domain 10.10.10.1 udp-port 5000
params securityname public
IV. Configuring NMS
The S7500 series switches support H3C's QuidView NMS. SNMPv3 adopts user name
and password authentication. In [Quidview Authentication Parameter], you need to set
a user name, choose security level, and set authorization mode, authorization
10.10.10.2
Switch A
Ethernet
Network diagram for SNMP
1-8
Chapter 1 SNMP Configuration