H3C S7500 Series Operation Manual page 113

Operation Manual – VLAN
H3C S7500 Series Ethernet Switches
Enter system view
Create protocol-based
VLAN on specific card
Caution:
It is necessary to add those ports that require protocol on the card to the
protocol-based VLAN.
Currently, only non-type-A cards, including LPUs and SRPUs, support this
command.
If a protocol-based VLAN has been associated with a card, the VLAN cannot be
removed.
If a protocol in a VLAN has been associated with a card, the protocol cannot be
removed from the VLAN.
Table 2-2
cards.
Table 2-2 Protocol-based VLAN creation commands on different cards
Command description
Create protocol-based
VLAN on specific card in
system view.
Create protocol-based
VLAN on specific port in
Ethernet port view.
Note:
Type A cards include LS81FT48A, LS81FM24A, LS81FS24A, LS81GB8UA,
LS81GT8UA, iSalience I, Salience I and Salience II.
To do...
system-view
protocol-vlan vlan vlan-id
{ protocol-index [ to
protocol-end ] | all } { slot
slot-number | mainboard }
shows the supported protocol-based VLAN creation commands on different
Not supported
Supported
Use the command...
Type-A card
Supported (only for all IP protocols
and subnet IP protocols.
Supported (exclude all IP protocols
and subnet IP protocols.
2-9
Chapter 2 VLAN Configuration
Remarks
—
Required
Non-type-A card