Configuring A Hybrid-Port-Based Vlan - H3C S5500-SI Series Operation Manual

Operation Manual – VLAN
H3C S5500-SI Series Ethernet Switches
Enter system view
Enter
Ethernet
port view
or port
group view
Configure the port link
type as Trunk
Allow the specified
VLANs to pass through
the current Trunk port
Configure the default
VLAN for the Trunk port
Note:
To convert a Trunk port into a Hybrid port (or vice versa), you need to use the
Access port as a medium. For example, the Trunk port has to be configured as an
Access port first and then a Hybrid port.
The default VLAN IDs of the Trunk ports on the local and peer devices must be the
same. Otherwise, packets cannot be transmitted properly.

1.4.4 Configuring a Hybrid-Port-Based VLAN

A Hybrid port may belong to multiple VLANs, and this configuration can only be
performed in Ethernet port view or port group view.
Follow these steps to configure the Hybrid-port-based VLAN:
To do... Use the command...
system-view
Enter
interface interface-type
Ethernet
interface-number
port view
port-group { manual
Enter port
port-group-name |
group view
aggregation agg-id }
port link-type trunk
port trunk permit vlan
{ vlan-id-list | all }
port trunk pvid vlan
vlan-id
1-9
Chapter 1 VLAN Configuration
Remarks
—
Use either command
In Ethernet port view, the
subsequent configurations
only apply to the current
port; in port group view, the
subsequent configurations
apply to all ports in the port
group.
Required
Required
By default, all Trunk ports
only allow packets of VLAN
1 to pass.
Optional
VLAN 1 is the default by
default.