H3C S7500 Series Operation Manual page 907

Operation Manual – System Maintenance and Debugging
H3C S7500 Series Ethernet Switches
Step 7: Use the put command to upload the file s7500.btm to the switch, as shown in
Figure 1-13.
Figure 1-13 Upload file s7500.btm to the switch
Step 8: Configure s7500.btm to be the Boot ROM at reboot, and then restart the switch.
<H3C> boot bootrom s7500.btm slot 0
This will update BootRom file on board 0 . Continue? [Y/N] y
Board 0 upgrading BOOTROM, please wait...
Upgrade board 0 BOOTROM succeeded!
<H3C> reboot
When rebooting the switch, use the file s7500.btm as Boot ROM to finish Boot ROM
loading.
2) Loading host software
Loading the host software is the same as loading the Boot ROM program, except for
that the file to be downloaded is the host software file, and that you need to use the
boot boot-loader command to select the host software at reboot of the switch.
Chapter 1 Boot ROM and Host Software
1-17
Loading