Link Aggregation Configuration; Configuring A Manual Aggregation Group - H3C S7500 Series Operation Manual

Operation Manual – Link Aggregation
H3C S7500 Series Ethernet Switches
Caution:
A load-sharing aggregation group contains at least two selected ports, however, a
non-load-sharing aggregation group can have one selected port at most and others are
standby ports.

1.2 Link Aggregation Configuration

Caution:
The following ports cannot be added to an aggregation group: destination ports to
be mirrored to, reflection ports of remote mirroring, ports configured with static MAC
addresses, static-ARP-enabled ports, and 802.1x-enabled ports.
Ports where the IP-MAC address binding is configured cannot be added to an
aggregation group.
Note that:
1) When creating an aggregation group:
If the aggregation group you are creating already exists but contains no port, its
type will change to the type you set.
If the aggregation group you are creating already exists and contains ports, the
possible type changes may be: changing from dynamic or static to manual, and
changing from dynamic to static; and no other kinds of type change can occur.
When you change a dynamic/static group to a manual group, the system will
automatically disable LACP on the member ports. When you change a dynamic
group to a static group, the system will remain the member ports LACP-enabled.
2) When a manual or static aggregation group contains only one port, you cannot
remove the port unless you remove the whole aggregation group.

1.2.1 Configuring a Manual Aggregation Group

You can create a manual aggregation group through the following operations. And you
can remove an existing manual aggregation group. After that, all the ports in the group
are removed from the group).
A port can only be manually added/removed to/from a manual aggregation group.
Follow these steps to configure a manual aggregation group:
Chapter 1 Link Aggregation Configuration
1-8