Dldp Configuration; Configuring Dldp - H3C S7500 Series Operation Manual

Operation Manual – DLDP
H3C S7500 Series Ethernet Switches

1.3 DLDP Configuration

1.3.1 Configuring DLDP

Note:
For a port with DLDP enabled, you are not recommended to execute the port monitor
last command on the port. If it is necessary, the value argument in this command must
be less than 10.
Follow these steps to configure DLDP:
Enter system view
Enable
DLDP
Set the authentication mode and
password
Set the interval of sending DLDP
packets
Set the delaydown timer
To do...
Enable DLDP
globally
Enter
Ethernet
Enable
port view
DLDP
on a
Enable
port
DLDP on
a port
1-10
Chapter 1 DLDP Configuration
Use the command...
system-view
dldp enable
interface interface-type
interface-number
dldp enable
dldp authentication-mode
{ none | simple
simple-password | md5
md5-password }
dldp interval value
dldp delaydown-timer
delaydown-time
Remarks
—
Required.
Enable DLDP
globally and
then enable
DLDP on the
specified port.
Optional
By default, the
authentication
mode is none,
that is,
authentication
is not
performed.
Optional. By
default, the
interval of
sending DLDP
packets is 5
seconds.
Optional
By default, the
delaydown
timer expires
after 1 second
it is triggered.