Displaying Acl Configuration; Acl Configuration Examples; Basic Acl Configuration Example - H3C S7500 Series Operation Manual

Operation Manual – ACL
H3C S7500 Series Ethernet Switches

1.10 Displaying ACL Configuration

Display a time range or time
ranges
Display the configured ACL
rule(s)
Display the statistics
information about the
configured ACL rules
Display the remain ACL
resource of a specified slot
Display the ACL mode of
traffic flows
Display information about the
ACL rules applied to port(s)
Display the matching order of
the applied ACL rules

1.11 ACL Configuration Examples

1.11.1 Basic ACL Configuration Example

I. Network requirements
Through basic ACL configuration, packets from the host with the source IP address of
10.1.1.1 (the host is connected to the switch through Ethernet 2/0/1) are to be filtered
within the time range from 8:00 to 18:00 everyday.
II. Network diagram
PC1
10.1.1.1
PC2
Figure 1-1 Network diagram for basic ACL configuration
To do...
Eth2/0/1
Switch
Use the command...
display time-range { all |
time-name }
display acl config { all | acl-number
| acl-name }
display acl config statistics
display acl remaining entry slot
slot-number
display acl mode
display acl running-packet-filter
{ all | interface interface-type
interface-number }
display acl order
To the router
1-22
Chapter 1 ACL Configuration
Remarks
These
commands
can be
executed in
any view.