Configuration Example; Configuring Tp; Configuration Prerequisites; Configuration Procedure Of Tp - H3C S7500 Series Operation Manual

Operation Manual – QoS
H3C S7500 Series Ethernet Switches
Enter QoS view
Configure port-based
rate limiting
Note:
Only non-type-A LPUs support port-based rate limiting.

1.6.3 Configuration Example

Configure rate limiting on GigabitEthernet 2/0/1 of the switch
Limit the rate to 10 Mbps.
Configuration procedure:
<H3C> system-view
[H3C] interface GigabitEthernet2/0/1
[H3C-GigabitEthernet2/0/1] qos
[H3C-qosb-GigabitEthernet2/0/1] line-rate 10

1.7 Configuring TP

Refer to

1.7.1 Configuration Prerequisites

ACL rules used for traffic identifying are defined. Refer to the ACL module in this
manual for defining ACL rules.
The limit rate for TP, the actions for the packets within the specified traffic
specification and the actions for the packets beyond the specified traffic
specification have been specified.
The ports that need this configuration are specified.

1.7.2 Configuration Procedure of TP

Follow these steps to configure TP:
Enter system view
Enter Ethernet port
view
Enter QoS view
To do...
qos
line-rate [ kbps ] target-rate
TP for information about TP.
To do...
system-view
interface interface-type
interface-number
qos
Use the command...
Use the command...
1-20
Chapter 1 QoS Configuration
Remarks
—
Required
Remarks
—
—
—