H3C S7500 Series Operation Manual page 53

Operation Manual – Login
H3C S7500 Series Ethernet Switches
To do...
Set the timeout time
for the user interface
Note that the level the commands of which are available to users logging into a switch
depends on both the authentication-mode password and the user privilege level
level command, as listed in the following table.
Table 2-5 Determine the command level
Authentication
Local password
authentication
(authentication-m
ode password)
2.5.2 Configuration Example
I. Network requirements
Assume that you are a level 3 VTY user and want to perform the following configuration
for users logging in through the console port:
Authenticate users logging in through the console port using the local password.
Set the local password to 123456 (in plain text).
The commands of level 2 are available to users logging into the AUX user
interface.
The baud rate of the console port is 19,200 bps.
The screen can contain up to 30 lines.
The history command buffer can store up to 20 commands.
The timeout time of the AUX user interface is 6 minutes.
Use the command...
idle-timeout minutes
[ seconds ]
User type
mode
Users logging in
through the
AUX user
interface
Chapter 2 Logging in through the Console Port
Optional
The default timeout time of a user
interface is 10 minutes.
With the timeout time being 10
minutes, the connection to a user
interface is terminated if no
operation is performed in the user
interface within 10 minutes.
You can use the idle-timeout 0
command to disable the timeout
function.
Scenario
Command
configuration
The user privilege level
level command is not
executed
The user privilege level
level command is
already executed
2-11
Remarks
Command
level
Level 3
Determined
by the level
argument