Route Capacity Configuration; Setting The Lower Limit And The Safety Value Of The Switch Memory; Enabling/Disabling Automatic Protocol Connection Recovery - H3C S7500 Series Operation Manual

Operation Manual – Routing Protocol
H3C S7500 Series Ethernet Switches
connection. If the automatic protocol connection recovery function is disabled, the
switch will not re-establish the disconnected IS-IS, BGP or OSPF connection even
when the free memory restores to a value larger than the safety value.

8.2 Route Capacity Configuration

Route capacity configuration includes:
Setting the lower limit and the safety value of switch memory
Enabling/disabling the switch to recover the disconnected routing protocol
automatically

8.2.1 Setting the Lower Limit and the Safety Value of the Switch Memory

Follow these steps to set the lower limit and the safety value of switch memory:
Enter system view
Set the lower limit and the
safety value of switch memory
Note:
The safety-value must be greater than the limit-value.

8.2.2 Enabling/Disabling Automatic Protocol Connection Recovery

Follow these steps to enable/disable automatic protocol recovery:
Enter system view
Enable automatic protocol
recovery
Disable automatic
protocol connection
recovery
To do...
To do...
system-view
memory auto-establish
enable
memory auto-establish
disable
Chapter 8 Route Capacity Configuration
Use the command...
system-view
memory { safety safety-value |
limit limit-value }*
Use the command...
8-2
Remarks
—
Optional
Remarks
—
Optional
By default, automatic
protocol connection
recovery is enabled.
Optional