H3C S7500 Series Operation Manual page 173

Operation Manual – GVRP
H3C S7500 Series Ethernet Switches
To do...
Enter system view
Configure the
LeaveAll timer
Enter Ethernet port
view
Configure the Hold,
Join, and Leave
timers
Exit and return to
system view
Enable GVRP
globally
Enter Ethernet port
view
Enable GVRP on the
port
Configure GVRP
port registration
mode
The timeout ranges of the timers vary depending on the timeout values you set for other
timers. If you want to set the timeout time of a timer to a value out of the current range,
you can set the timeout time of the associated timer to another value to change the
timeout range of this timer.
The following table describes the relations between the timers:
Use the command...
system-view
garp timer leaveall
timer-value
interface interface-type
interface-number
garp timer { hold | join
| leave } timer-value
quit
gvrp
interface interface-type
interface-number
gvrp
gvrp registration
{ fixed | forbidden |
normal }
1-5
Chapter 1 GVRP Configuration
Remarks
—
Optional
By default, the LeaveAll timer is
set to 1,000 centiseconds.
—
Optional
By default, the Hold, Join, and
Leave timers are set to 10, 20,
and 60 centiseconds
respectively.
—
Required
By default, GVRP is disabled
globally.
—
Required
By default, GVRP is disabled on
the port.
After you enable GVRP on a trunk
port, you cannot change the port
to a different type.
Optional
You can choose one of the three
modes.
By default, GVRP port
registration mode is normal.