Cutting Down User Connections; Radius Configuration - H3C S7500 Series Operation Manual

Operation Manual – AAA & RADIUS & HWTACACS & EAD
H3C S7500 Series Ethernet Switches

1.3.7 Cutting Down User Connections

Table 1-11 Cut down user connection
To do...
Enter system view
Cut down user
connections forcibly
Note:
You can use the display connection command to display Telnet user connections,
but cannot use the cut connection command to cut down their connections.
You can use neither the display connection command to display FTP or SFTP
user connections, nor the cut connection command to cut down their connections..

1.4 RADIUS Configuration

RADIUS protocol is configured scheme by scheme. In an actual network environment,
you can either use a single RADIUS server or two RADIUS servers (primary and
secondary servers with the same configuration but different IP addresses) in a RADIUS
scheme. After creating a new RADIUS scheme, you should configure the IP address
and UDP port number of each RADIUS server you want to use in this scheme. These
RADIUS servers fall into two types: authentication/authorization, and accounting. And
for each kind of server, you can configure two servers in a RADIUS scheme: primary
server and secondary server. A RADIUS scheme has the following attributes: IP
addresses of the primary and secondary servers, shared keys, and types of the
RADIUS servers.
In an actual network environment, you can configure the above parameters as required.
But you should configure at least one authentication/authorization server and one
accounting server, and at the same time, you should keep the RADIUS service port
settings on the switch consistent with those on the RADIUS servers.
Use the command...
system-view
cut connection { all | access-type { dot1x |
mac-authentication } | domain isp-name |
interface interface-type interface-number | ip
ip-address | mac mac-address |
radius-scheme radius-scheme-name | vlan
vlan-id | ucibindex ucib-index | user-name
user-name }
1-21
Chapter 1 AAA & RADIUS & HWTACACS
Configuration
Remarks
—
Required