Configuring Traffic Mirroring - H3C S7500 Series Operation Manual

Operation Manual – Mirroring
H3C S7500 Series Ethernet Switches
reflector port: GigabitEthernet2/0/3
remote-probe vlan: 10
# Configure Switch B.
<H3C> system-view
[H3C] vlan 10
[H3C-vlan10] remote-probe vlan enable
[H3C-vlan10] quit
[H3C] interface GigabitEthernet 2/0/1
[H3C-GigabitEthernet2/0/1] port link-type trunk
[H3C-GigabitEthernet2/0/1] port trunk permit vlan 10
[H3C-GigabitEthernet2/0/1] quit
[H3C] interface GigabitEthernet 2/0/2
[H3C-GigabitEthernet2/0/2] port link-type trunk
[H3C-GigabitEthernet2/0/2] port trunk permit vlan 10
# Configure Switch A.
<H3C> system-view
[H3C] vlan 10
[H3C-vlan10] remote-probe vlan enable
[H3C-vlan10] quit
[H3C] interface GigabitEthernet 2/0/1
[H3C-GigabitEthernet2/0/1] port link-type trunk
[H3C-GigabitEthernet2/0/1] port trunk permit vlan 10
[H3C-GigabitEthernet2/0/1] quit
[H3C] mirroring-group 1 remote-destination
[H3C] mirroring-group 1 monitor-port GigabitEthernet 2/0/2
[H3C] mirroring-group 1 remote-probe vlan 10
[H3C] display mirroring-group remote-destination
mirroring-group 1:
type: remote-destination
status: active
monitor port: GigabitEthernet2/0/2
remote-probe vlan: 10

1.3.3 Configuring Traffic Mirroring

I. Configuration prerequisites
ACLs for identifying traffics have been defined. For defining ACLs, see the
description on the ACL module in this manual.
The destination port has been defined.
The port on which to perform traffic mirroring configuration and the direction of
traffic mirroring has been determined.
Chapter 1 Mirroring Configuration
1-13