H3C S7500 Series Operation Manual page 904

Operation Manual – System Maintenance and Debugging
H3C S7500 Series Ethernet Switches
Note:
Before restarting the switch, make sure you have saved all other configurations that
you want, so as to avoid losing configuration information.
2) Loading host software
Loading the host software is the same as loading the Boot ROM program, except for
that the file to be downloaded is the host software file, and that you need to use the
boot boot-loader command to select the host software at reboot of the switch.
After the above operations, the Boot ROM and host software loading is completed.
Pay attention to the following:
The loading of Boot ROM and host software takes effect only after you restart the
switch with the reboot command.
If the space of the Flash memory is not enough, you can delete the useless files in
the Flash memory before software downloading.
No power-down is permitted during software loading.
II. Loading Process Using FTP Server
As shown in
switch, and then execute the FTP commands to download the Boot ROM program
s7500.btm from the switch.
1) Loading Boot ROM
Switch
FTP Server
192 .168 .0.75
Figure 1-9 Remote loading using FTP serve
Step 1: As shown in
(with IP address 10.1.1.1)
Step 2: Configure the IP address of VLAN 1 on the switch to 192.168.0.75, and subnet
mask to 255.255.255.0.
Figure 1-9, the switch is used as the FTP server. You can telnet to the
Internet
Ethernet port
Figure 1-9, connect the switch through an Ethernet port to the PC
Chapter 1 Boot ROM and Host Software
PC
FTP Client
10 .1 .1.1
r
1-14
Loading