H3C S7500 Series Operation Manual page 159

Operation Manual – IP Address-IP Performance-IPX
H3C S7500 Series Ethernet Switches
Follow these steps to configure IPX GNS:
Enter system view
Enable IPX
Configure
GNS reply
of IPX
SAP
Enter VLAN interface view
Configure an IPX network
number for the VLAN
interface
Disable GNS reply on the
current VLAN interface
IV. Configuring IPX service information
Generally, clients can only use the services that are advertised by NetWare servers and
saved on the switch. To make a specific service always available to the clients, you can
manually add it into the service information table as a static entry. If the route for the
static service entry is invalid or deleted, the broadcast of the static service entry is
disabled until the switch finds a valid route for the service entry.
IPX can support up to 10,240 service information entries with up to 5,120 service types
and 5,120 static service information entries. You can configure the maximum number of
service entries for one service type.
To do...
system-view
ipx enable
Respond to
GNS requests
with the
information of ipx sap
the server gns-load-balance
picked out by
round-robin
polling
Respond to
GNS requests
with the
undo ipx sap
information of gns-load-balance
the nearest
server
interface
Vlan-interface
vlan-id
ipx network
network
ipx sap
gns-disable-reply
Use the
command...
—
Required
Disabled by default.
Optional
By default, the switch responds
to SAP GNS requests with the
information of a server that is
picked out in turn from all the
known servers. This prevents a
server from getting overloaded.
Optional
By default, the switch responds
to SAP GNS requests with the
information of a server that is
picked out in turn from all the
known servers. This prevents a
server from getting overloaded.
—
Required
By default, the system does not
assign network numbers to
VLAN interfaces. That is, IPX is
disabled on all VLAN
interfaces.
Optional
By default, the VLAN interface
responds to GNS requests.
3-8
Chapter 3 IPX Configuration
Remarks