Queue Traffic Monitoring Configuration Example; Configuring Error Packets Monitoring; Error Packets Monitoring Configuration Task - H3C S7500 Series Operation Manual

Operation Manual – System Maintenance and Debugging
H3C S7500 Series Ethernet Switches
Enter system view
Enable queue traffic
monitoring
Set the overall traffic
threshold

4.5.2 Queue Traffic Monitoring Configuration Example

I. Network requirements
Enable queue traffic monitoring.
Set the overall traffic threshold used in queue traffic monitoring to 90 Mbps.
II. Configuration procedure
# Enter system view.
<H3C> system-view
[H3C]
# Enable queue traffic monitoring.
[H3C] qe monitor enable
# Set the overall traffic threshold used in queue traffic monitoring to 90 Mbps.
[H3C] qe monitor overflow-threshold 90000000

4.6 Configuring Error Packets Monitoring

If the switch receives a great number of error packets, it will not be able to send/receive
packets properly. With error packets monitoring enabled, the switch collects information
about received error packets regularly. If error packets are detected, it takes protection
measures to ensure that its interfaces send/receive packets properly.

4.6.1 Error Packets Monitoring Configuration Task

The following describes configuration tasks of error packets monitoring.
Follow these steps to configure error packets monitoring:
Enter the system view
Set the interval for
detecting error packets
To do... Use the command...
system-view
qe monitor enable
qe monitor
overflow-threshold
threshold
To do...
system-view
qe monitor errpkt
check-time interval
—
Required
This function is enabled by
default.
Optional
300,000,000 bps by default.
Use the command...
4-9
Chapter 4 Device Management
Remarks
Remarks
—
Optional
Defaults to 5 seconds.