H3C S7500 Series Operation Manual page 733

Operation Manual – Mirroring
H3C S7500 Series Ethernet Switches
Note:
When a switch acts as a remote port mirroring intermediate switch, to realize the data
mirroring successfully, you are recommended to configure redirection on the inbound
interface and redirect all the packets in the remote-probe VLAN to the corresponding
outbound interface.
IV. Configuring remote port mirroring on the destination switch
Enter system view
Create a remote-probe
VLAN and enter VLAN
view
Define the current VLAN
as a remote-probe VLAN
Exit the current view
Enter Ethernet port view
of the port through which
the destination switch is
connected to the source
switch or an intermediate
switch
Configure the current port
as a trunk port
Configure Trunk port to
permit packets from the
remote-probe VLAN
Exit current view
Configure the remote
destination mirroring
group
To do...
system-view
vlan vlan-id
remote-probe vlan
enable
quit
interface interface-type
interface-number
port link-type trunk
port trunk permit vlan
remote-probe-vlan-id
quit
mirroring-group group-id
remote-destination
Use the command...
1-10
Chapter 1 Mirroring Configuration
Remarks
—
vlan-id is the ID of the
remote-probe VLAN.
Required
—
—
Required
By default, the type of the
port is access.
Required
This configuration is
necessary for ports
through which the
destination switch is
connected to the source
switch or an intermediate
switch.
—
Required