Easy Ip; Internal Server; Special Protocols Supported By Nat; Configuring Nat - H3C S7500 Series Operation Manual

Hide thumbs Also See for S7500 Series:
Table of Contents

Advertisement

Operation Manual – NAT, Netstream, Policy Routing
H3C S7500 Series Ethernet Switches
which internal hosts the response packets should be forwarded to depending on the
destination addresses and port numbers carried in the packets.

1.2.3 Easy IP

The Easy IP feature enables you to associate an ACL directly with the IP address of a
VLAN interface that connects to the Internet by using the nat outbound command, so
that the NAT translates the source IP addresses of matching packets to this interface
address. This feature is useful when only one public IP address (the interface address)
is available or there are few internal hosts.

1.2.4 Internal Server

NAT conceals an internal network from the Internet and acts as a shield for internal
hosts. But in practical applications, it might be required to allow external hosts to
access certain internal devices such as internal WWW servers or FTP servers. By
using NAT, you can flexibly add internal servers with public IP addresses so that the
servers can be accessed by external hosts. For example, you can:
Configure public IP address 202.169.10.10 for an internal WWW server.
Configure public IP address 202.110.10.11 for an internal FTP server.
Configure public IP address and port number 202.110.10.12:8080 for an internal
WWW server.

1.2.5 Special Protocols Supported by NAT

The Comware NAT platform not only implements general NAT features, but also
provides complete NAT application-level gateway mechanism, enabling itself to
support a variety of special application protocols without any changing on the platform.
It has good scalability.
The special protocols supported by NAT include Internet control message protocol
(ICMP), domain name system (DNS), Internet locator service (ILS), H.323, FTP, and
NetMeeting 3.01.

1.3 Configuring NAT

1.3.1 NAT Configuration Task List

Complete the following tasks to configure NAT:
Configuring a NAT Address Pool
Configuring NAT
Configuring Internal Server
Task
1-5
Chapter 1 NAT Configuration
Remarks
Required
Required
Required

Advertisement

Table of Contents
loading

Table of Contents