Displaying The Device Management Configuration; Remote Switch Update Configuration Example - H3C S7500 Series Operation Manual

Operation Manual – System Maintenance and Debugging
H3C S7500 Series Ethernet Switches

4.7 Displaying the Device Management Configuration

After the above configurations, you can execute the display command in any view to
display the operating status of the device management to verify the configuration
effects.
Follow these steps to display the operating status of the device management:
Display the APP to be adopted
at reboot
Display the module type and
operating status of each board
Display information about
environment used by a switch
Display the operating status of
the built-in fan
Display the usage of s switch
Display memory usage of a
switch
Display the operating status of
the power supply

4.8 Remote Switch Update Configuration Example

I. Network requirements
Telnet to the switch from a PC remotely and download applications from the FTP server
to the Flash memory of the switch to remotely update the switch software by using the
device management commands through CLI.
The switch acts as the FTP client, and the remote PC serves as both the configuration
PC and the FTP server.
Perform the following configuration on the FTP server.
Configure an FTP user, whose name and password are switch and hello
respectively. Authorize the user with the read-write right of the Switch directory on
the PC.
Make appropriate configuration so that the IP address of a VLAN interface on the
switch is 1.1.1.1, the IP address of the PC is 2.2.2.2, and the switch and the PC is
reachable to each other.
To do... Use the command...
display boot-loader
display device [ detail | [ shelf
shelf-no ] [ frame frame-no ] [ slot
slot-number ] ]
display environment
display fan [ fan-id ]
display cpu [ slot slot-number ]
display memory [ slot slot-number
| limit ]
display power [ power-id ]
4-11
Chapter 4 Device Management
Remarks
Available in
any view.