Telnet Configuration With Authentication Mode Being Password - H3C S7500 Series Operation Manual

Operation Manual – Login
H3C S7500 Series Ethernet Switches
[H3C-ui-vty0] user privilege level 2
# Configure Telnet protocol is supported.
[H3C-ui-vty0] protocol inbound telnet
# Set the maximum number of lines the screen can contain to 30.
[H3C-ui-vty0] screen-length 30
# Set the maximum number of commands the history command buffer can store to 20.
[H3C-ui-vty0] history-command max-size 20
# Set the timeout time to 6 minutes.
[H3C-ui-vty0] idle-timeout 6
3.3 Telnet Configuration with Authentication Mode Being
Password
3.3.1 Configuration Procedure
Follow these steps to perform Telnet configuration with the authentication mode being
password:
Enter system view
Enter one or more VTY
user interface views
Configure to authenticate
users logging into VTY
user interfaces using the
local password
Set the local password
Configure the command
level available to users
logging into the user
interface
Configure the protocol to
be supported by the user
interface
Make terminal services
available
To do...
system-view
user-interface vty
first-number
[ last-number ]
authentication-mode
password
set authentication
password { cipher |
simple } password
user privilege level level
protocol inbound { all |
ssh | telnet }
shell
Chapter 3 Logging in through Telnet
Use the command...
3-6
Remarks
—
—
Required
Required
Optional
By default, commands of
level 0 are available to
users logging into VTY
user interface.
Optional
By default, both Telnet
protocol and SSH protocol
are supported.
Optional
By default, terminal
services are available in
all user interfaces.