H3C S7500 Series Operation Manual page 928

Operation Manual – System Maintenance and Debugging
H3C S7500 Series Ethernet Switches
The host software switch.app and the Boot ROM file boot.btm of the switch are stored
into the directory of the switch. Use FTP to download the switch.app and boot.btm files
from the FTP server to the switch.
II. Network diagram
2.2.2.2
PC
Figure 4-1 Network diagram of FTP configuratio
III. Configuration procedure
1) Configure the following FTP server–related parameters on the PC: an FTP user
with the username and password as switch and hello respectively, and specify the
working directory of the user as Switch. The detailed configuration is omitted here.
2) Configure the switch as follows:
# On the switch, configure a level 3 telnet user with the username and password as
user and hello respectively. Authentication by user name and password is required for
the user.
Note:
Refer to Login Configuration and Login Commands in this manual for configuration
commands and steps about telnet user.
# Execute the telnet command on the PC to log into the switch. The following prompt
appears:
<H3C>
Caution:
If the Flash memory of the switch is not sufficient, delete the original applications in it
before downloading the new ones.
# Initiate an FTP connection with the following command in user view. Input the correct
user name and password to log into the FTP server.
<H3C> ftp 2.2.2.2
1.1.1.1
Network
4-12
Chapter 4 Device Management
Switch
n