Port Basic - H3C S7500 Series Operation Manual

Operation Manual – Overview
H3C S7500 Series Ethernet Switches
Module

09- Port Basic

configuration
10-Link
Aggregation
11-Port Isolation
12-Port Binding
13-DLDP
14-MAC Address
Table
15-MSTP
16-Routing
Protocol
17-Multicast
18-802.1x
19-AAA-RADIUS-H
WTACACS-EAD
20-Traffic
Accounting
21-VRRP-HA
Features supported
Three port states: access, trunk, hybrid
Global broadcast suppression on ports
Loopback detection
Cable test
LACP (link aggregation control protocol)
Port isolation group configuration
MAC address-to-port binding
DLDP (device link detection protocol)
Manually configuring dynamic/static MAC address entries
Configuring the aging time of MAC address entries
Configuring the maximum number of MAC addresses that
can be learned on a port
Inter-chip synchronization of MAC address entries
STP (spanning tree protocol)/RSTP (rapid STP)/MSTP
(multiple STP)
QinQ BPDU tunneling
H3C's MSTP path cost standard
Static routing
RIP (routing information protocol) v1/v2
OSPF (open shortest path first)
BGP (border gateway protocol)
IS-IS (intermediate system-to-intermediate system)
Route policy
IGMP Snooping (internet group management protocol
snooping)
IGMP (internet group management protocol)
PIM-DM (protocol-independent multicast-dense mode)
PIM-SM (protocol-independent multicast-sparse mode)
802.1x authentication
Guest VLAN
HABP (Huawei authentication bypass protocol)
AAA (authentication, authorization and accounting)
RADIUS (remote authentication dial-in user service)
HWTACACS (Huawei terminal access controller access
control system)
EAD (endpoint admission defense)
Only supported by the LS81VSNP service card
VRRP (virtual router redundancy protocol)
HA (high availability)
3-6
Chapter 3 Product Overview