Basic Rip Configuration; Configuring Basic Rip Functions - H3C S7500 Series Operation Manual

Hide thumbs Also See for S7500 Series:

Table of Contents

Operation Manual – Routing Protocol

H3C S7500 Series Ethernet Switches

Configuring RIP

Route Control

Adjustment and

Optimization

3.3 Basic RIP Configuration

3.3.1 Configuration Prerequisites

Before configuring basic RIP functions, perform the following tasks:

Configuring the link layer protocol

Configuring IP address on each interface, and make sure that all adjacent nodes

are reachable with each other

I. Enable RIP and specify networks

Follow these steps to enable RIP globally and on the interface of a specified network

Enable RIP and specify networks

Set the RIP operating status on an interface

Specify the RIP version on an interface

Set the additional routing metrics of an

Configure RIP route summarization

Disable the receiving of host routes

Configure inbound/outbound route filtering

Set RIP preference

Enable RIP traffic sharing

Configure RIP route redistribution

Configure RIP timers

Configure split horizon

Configure RIP-1 packet zero field check

Set RIP-2 packet authentication mode

Configure a RIP neighbor

Chapter 3 RIP Configuration

Table of Contents