Configuring The Interval To Perform Statistical Analysis On Port Traffic; Setting Speedup For A Port - H3C S7500 Series Operation Manual

Operation Manual – Port Basic Configuration
H3C S7500 Series Ethernet Switches
Enter system view
Enter Ethernet port view
Enable the system to test the
cable connected to the port

1.1.7 Configuring the Interval to Perform Statistical Analysis on Port Traffic

By performing the following configuration, you can set the interval to perform statistical
analysis on the traffic of a port.
When you use the display interface interface-type interface-number command to
display the information of a port, the system displays the average rates of the traffic flow
passing through the port during the specified interval. For example, if you set this
interval to 100 seconds, the displayed information is as follows:
Last 100 seconds input:
Last 100 seconds output:
Follow these steps to set the interval to perform statistical analysis on port traffic:
Enter system view
Enter Ethernet port view
Set the interval to perform
statistical analysis on port
traffic

1.1.8 Setting Speedup for a Port

Follow these steps to set speedup for a port:
Enter system view
Enable the hardware
speedup function inside
the port
Disable the hardware
speedup function inside
the port
To do...
0 packets/sec 0 bytes/sec
0 packets/sec 0 bytes/sec
To do...
system-view
interface interface-type
interface-number
flow-interval interval
To do...
system-view
hardspeedup enable
hardspeedup disable
Use the command...
system-view
interface interface-type
interface-number
virtual-cable-test
Use the command...
Use the command...
1-6
Chapter 1 Port Basic Configuration
Remarks
—
—
Required
Remarks
—
—
Optional
By default, this interval is
300 seconds.
Remarks
—
Optional
By default, the hardware
speedup function inside
the port is enabled.