Assistant Edge Node Configuration; Assistant Edge Node Configuration Tasks - H3C S7500 Series Operation Manual

Operation Mannual – RRPP
H3C S7500 Series Ethernet Switches
Define the switch as an edge node on subring 2 in RRPP domain 1, the port
GigabitEthernet 2/0/2 as the common port, the port GigabitEthernet 2/0/4 as the
edge port.
II. Configuration procedure
<H3C> system-view
[H3C] rrpp domain 1
[H3C-rrpp-domain1] control-vlan 4092
[H3C-rrpp-domain1] ring 1 node-mode transit primary-port GigabitEthernet2/0/1
secondary-port GigabitEthernet2/0/2 level 0
[H3C-rrpp-domain1] ring 2 node-mode edge common-port GigabitEthernet 2/0/2
edge-port GigabitEthernet 2/0/4
[H3C-rrpp-domain1] ring 1 enable
[H3C-rrpp-domain1] ring 2 enable
[H3C-rrpp-domain1] quit
[H3C] rrpp enable
[H3C] display rrpp brief
[H3C] display rrpp verbose domain 1
[H3C] display rrpp statistics domain 1

1.5 Assistant Edge Node Configuration

1.5.1 Assistant Edge Node Configuration Tasks

Follow these steps to configure an assistant edge node:
Enter system view
Create an RRPP domain,
and enter RRPP domain
view
Specify a control VLAN
for the RRPP domain
Specify the current
switch as a transit node
of the primary ring, and
specify the primary port
and the secondary port
Specify the current
switch as an assistant
edge node of the subring,
and specify a common
port and an edge port
To do...
system-view
rrpp domain domain-id
control-vlan vlan-id
ring ring-id node-mode
transit [ primary-port
pri-port ] [ secondary-port
sec-port ] level level-value
ring ring-id node-mode
assistant-edge
[ common-port
comm-port ] [ edge-port
edge-port ]
Use the command...
1-14
Chapter 1 RRPP Configuration
Remarks
—
Required.
The command prompt of
RRPP domain view
depends on the domain-id
you input.
Required
Required.
Level 0 identifies the
primary ring and level 1
identifies a subring.
Required