Tftp Configuration - H3C S7500 Series Operation Manual

Operation Manual – FTP and TFTP
H3C S7500 Series Ethernet Switches
Note:
Before performing TFTP-related configurations, you need to configure IP addresses
of the TFTP client and the TFTP server, and make sure that they are reachable to
each other .
A switch can only function as a TFTP client.
Switch Switch
Figure 1-4 Network diagram for TFTP configuration
Table 1-3
Table 1-3 Configurations needed when a switch functions as a TFTP client
Device
Switch
TFTP
server

1.2.2 TFTP Configuration

I. Prerequisites
A switch functions as a TFTP client and a remote PC functions as a TFTP server. The
network operates properly, as shown in
II. Basic TFTP configurations
Follow these steps to perform basic TFTP configurations:
Network Network
Network Network
describes the operations needed when a switch functions as a TFTP client.
Configuration
Configure an IP address
for the VLAN interface of
the switch so that it is
reachable to the TFTP
server.
You can log into a TFTP
server directly for file
accessing through TFTP
commands.
The TFTP server is started
and the TFTP work
directory is configured.
Chapter 1 FTP and TFTP Configuration
PC PC
Default
The TFTP applies to networks
where client-server interactions
are comparatively simple. It
—
requires that the switch and the
TFTP server are reachable to
each other.
— —
— —
Figure 1-4.
1-11
Description