Layer 3 Connectivity Detection Configuration Example; Configuring Queue Traffic Monitoring; Queue Traffic Monitoring Configuration Task - H3C S7500 Series Operation Manual

Operation Manual – System Maintenance and Debugging
H3C S7500 Series Ethernet Switches
Enter system view
Enter Ethernet interface
view
Enable Layer 3
connectivity detection
function
Display information about
Layer 3 connectivity
between the local device
and the remote device

4.4.3 Layer 3 Connectivity Detection Configuration Example

I. Network requirements
The physical link between the local peer and the remote peer is correct. The local
peer port that is used to connect is Ethernet 4/0/1.
The IP address of the Lay 3 interface of the remote peer is 1.1.1.1.
II. Configuration procedure
# Enter system view.
<H3C> system-view
[H3C]
# Enter Ethernet interface view.
[H3C] interface Ethernet 4/0/1
# Enable Layer 3 connectivity detection on Ethernet 4/0/1 interface and specify the IP
address of the device (1.1.1.1) to be detected.
[H3C-Ethernet4/0/1] uplink monitor ip 1.1.1.1

4.5 Configuring Queue Traffic Monitoring

Upon enabling queue traffic monitoring on a switch, the switch monitors the queue
traffic and relieves blocks in the output queue of its interfaces.
The criterion used to distinguish a block is that the queue is full, and the traffic of the
corresponding interface is less than the specified threshold.

4.5.1 Queue Traffic Monitoring Configuration Task

The following describes configuration tasks of queue traffic monitoring.
Follow these steps to configure queue traffic monitoring:
To do...
system-view
interface interface-type
interface-number
uplink monitor ip
ip-address
display uplink monitor
Use the command...
4-8
Chapter 4 Device Management
Remarks
—
—
Required
Optional
You can execute the
display command in any
view.