Setting The Processing Method For Specific Packets; Displaying Mac Address Configuration - H3C S7500 Series Operation Manual

Operation Manual – MAC Address Table
H3C S7500 Series Ethernet Switches

1.2.7 Setting the Processing Method for Specific Packets

Follow these steps to set the packet processing method of a switch when it receives a
packet whose destination MAC address is the bridge MAC address of the switch:
Enter system view
Enable the switch to pass
the packet whose
destination MAC address is
the bridge MAC address of
the switch to the CPU for
processing
Disable the switch from
passing the packet whose
destination MAC address is
the bridge MAC address of
the switch to the CPU for
processing

1.3 Displaying MAC Address Configuration

Display information about the
MAC address table
Display the aging time of the
dynamic MAC address entries
in the MAC address table
1.4 Configuration Example
1.4.1 Network Requirements
Log into the switch through the console port and enable address table
configuration.
Set the aging time of dynamic MAC address entries to 500 seconds.
Add a static MAC address entry 000f-e235-dc71 for port Ethernet 2/0/2 (assuming
that the port belongs to VLAN 1).
1.4.2 Configuration Procedure
# Enter system view.
<H3C> system-view
To do...
system-view
bridgemactocpu
enable
bridgemactocpu
disable
To do...
Chapter 1 MAC Address Table Management
Use the command...
Use the command...
display mac-address
[ display-option ]
display mac-address
aging-time
1-7
Remarks
—
Optional
By default, packets with
the destination MAC
address being the bridge
MAC address of the
switch are not passed to
the CPU for processing.
Optional
Remarks
Available in any
view.