H3C S7500 Series Operation Manual page 731

Operation Manual – Mirroring
H3C S7500 Series Ethernet Switches
Enter port view of ports
that connected to the
intermediate switch or
destination switch
Configure the current port
as a trunk port
Configure Trunk port to
permit packets from the
remote-probe VLAN
Exit current view
Configure a remote
source mirroring group
Configure a source port
for remote mirroring
Configure a remote
reflector port
Configure the
remote-probe VLAN for
the remote source
mirroring group
Display the configuration
of the remote source
mirroring group
To do...
interface interface-type
interface-number
port link-type trunk
port trunk permit vlan
remote-probe-vlan-id
quit
mirroring-group group-id
remote-source
mirroring-group group-id
mirroring-port
mirroring-port-list { both |
inbound | outbound }
mirroring-group group-id
reflector-port
reflector-port
mirroring-group group-id
remote-probe vlan
remote-probe-vlan-id
display mirroring-group
remote-source
Use the command...
1-8
Chapter 1 Mirroring Configuration
Remarks
—
Required
By default, the type of the
port is access.
Required
This setting is required for
source switch ports that
connected with the
intermediate switch or
destination switch.
—
Required
Required
Required
The remote reflector port
must be of the Access
type. LACP and STP must
be disabled on this port.
After a port is configured
as a reflector port, the
switch does not allow you
to perform any of the
following configurations:
Changing the port type
and its default VLAN
ID
Add it to another VLAN
Required
Optional
This command can be
executed in any view.