Basic Ospf Configuration - H3C S7500 Series Operation Manual

Operation Manual – Routing Protocol
H3C S7500 Series Ethernet Switches
OSPF Network Type
Configuration
OSPF Route Control
OSPF Network
Adjustment and
Optimization

4.3 Basic OSPF Configuration

Before you can configure other OSPF features, you must first enable OSPF and
specify the interface and area ID.
4.3.1 Configuration Prerequisites
Before configuring OSPF, perform the following tasks:
Configuring the link layer protocol
Configuring the network layer addresses of interfaces so that adjacent nodes are
reachable to each other at the network layer
Task
Configuring the Network Type of an
OSPF Interface
Setting an NBMA Neighbor
Setting the DR Priority on an OSPF
Interface
Configuring OSPF Route Summary
Configuring OSPF to Filter Received
Routes
Configuring the Cost for Sending
Packets on an OSPF Interface
Setting OSPF Route Priority
Configuring OSPF to Redistribute
Routes
Configuring OSPF Timers
Configuring the LSA transmission
delay
Configuring the SPF Calculation
Interval
Disabling OSPF Packet Transmission
on an Interface
Configuring OSPF Authentication
Configuring to Fill the MTU Field
When an Interface Transmits DD
Packets
Configuring OSPF Network
Management System (NMS)
4-9
Chapter 4 OSPF Configuration
Remarks
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional