H3C S7500 Series Operation Manual page 46

Operation Manual – Login
H3C S7500 Series Ethernet Switches
Table 2-2 Common configuration of console port login
Console port
configuration
AUX user
interface
configuration
Terminal
configuration
Caution:
Changing of console port configuration terminates the connection to the console port.
To establish the connection again, you need to modify the configuration of the terminal
emulation program running on your PC accordingly. Refer to
configuration.
Configuration
Baud rate
Check mode
Stop bits
Data bits
Configure the
command level
available to the
users logging
into the AUX
user interface
Make terminal
services
available
Set the
maximum
number of lines
the screen can
contain
Set history
command buffer
size
Set the timeout
time of a user
interface
Chapter 2 Logging in through the Console Port
Remarks
Optional
The default baud rate is 9,600 bps.
Optional
By default, the check mode of the console port is
set to none, which means no check bit.
Optional
The default stop bits of a console port is 1.
Optional
The default data bits of a console port is 8.
Optional
By default, commands of level 3 are available to
the users logging into the AUX user interface.
Optional
By default, terminal services are available in all
user interfaces
Optional
By default, the screen can contain up to 24 lines.
Optional
By default, the history command buffer can
contain up to 10 commands.
Optional
The default timeout time is 10 minutes.
2-4
Figure 2-4 for the