Habp Client Configuration; Displaying Habp - H3C S7500 Series Operation Manual

Operation Manual – 802.1x
H3C S7500 Series Ethernet Switches
To do...
Configure the
current switch to be
an HABP server
Configure the
interval to send
HABP request
packets

2.3 HABP Client Configuration

HABP clients reside on the switches attached to the HABP server. After you enable
HABP on a switch, the switch operates as an HABP client by default. So you only need
to enable HABP on a switch.
Table 2-2 Configure an HABP client
To do...
Enter system view
Enable HABP

2.4 Displaying HABP

After performing the above configuration, you can display and verify HABP
configuration by executing the display command in any view.
Table 2-3 Display HABP
Display information about HABP
configuration and status
Display information about the MAC
address table maintained by HABP
Display statistics of HABP packets
Use the command...
habp server vlan
vlan-id
habp timer interval
Use the command...
system-view
habp enable
To do...
2-2
Chapter 2 HABP Configuration
Required
By default, a switch operates as
an HABP client after you enable
HABP on the switch, and if you
want to use the switch as a
management switch, you must
configure the switch to be an
HABP server.
Optional
20 seconds by default
Remarks
—
Optional
Enabled by default
A switch operates as an HABP client
after you enable HABP on it.
Use the command...
display habp
display habp table
display habp traffic
Remarks
Remarks
In any view