Configuring The Poe Feature Of A Switch; Configuring The Poe Feature Of A Poe-Enabled Board - H3C S7500 Series Operation Manual

Operation Manual – PoE
H3C S7500 Series Ethernet Switches
Setting the PoE Feature of a PoE Port
Upgrading the PSE Processing Software Online

1.2.2 Configuring the PoE Feature of a Switch

Follow these steps to configure the PoE feature on a port:
Enter system view
Configure the maximum
PoE power that a switch
can supply
Note:
When setting the maximum PoE power supplied by the switch with the poe power
max-value command, you must set it to a value greater than the total power that has
been distributed to the boards. Otherwise, this command cannot be executed
successfully. The maximum power that a switch can supply ranges from 37 W to 2,400
W.

1.2.3 Configuring the PoE Feature of a PoE-enabled Board

Follow these steps to configure the PoE feature of a PoE-enabled board:
To do...
Enter system view
Set the PoE
management mode
of the switch
Enable the PoE
feature of the board
Set the maximum
power that the board
can supply
Task
To do...
system-view
poe power max-value
max-value
Use the command...
system-view
poe power-management
{ auto | manual } slot
slot-number
poe enable slot slot-number
poe max-power max-power
slot slot-number
Use the command...
1-4
Chapter 1 PoE Configuration
Remarks
Required
Optional
Remarks
—
Optional
By default, the maximum
PoE power that a switch
can supply is 2,400 W.
Remarks
—
Optional
By default, the switch
manages PoE in the manual
mode.
Optional
By default, the PoE feature is
disabled on a board.
Optional
By default, a board provides
up to 37W of power.