Configuring The Supported Radius Server Type; Configuring The Status Of Radius Servers - H3C S7500 Series Operation Manual

Operation Manual – AAA & RADIUS & HWTACACS & EAD
H3C S7500 Series Ethernet Switches

1.4.6 Configuring the Supported RADIUS Server Type

Table 1-17 Configure the supported RADIUS server type
To do...
Enter system view
Create a RADIUS
scheme and enter its
view
Specify the type of
RADIUS server
supported by the
switch

1.4.7 Configuring the Status of RADIUS Servers

For the primary and secondary servers (authentication/authorization servers, or
accounting servers) in a RADIUS scheme:
When the switch fails to communicate with the primary server due to some server
trouble, the switch will actively exchange packets with the secondary server.
After the time the primary server keeps in the block state exceeds the time set with the
timer quiet command, the switch will try to communicate with the primary server again
when it receives a RADIUS request. If the primary server recovers, the switch
immediately restores the communication with the primary server instead of
communicating with the secondary server, and at the same time restores the status of
the primary server to the active state while keeping the status of the secondary server
unchanged.
When both the primary and secondary servers are in active or block state, the switch
sends packets to the primary server only.
Table 1-18 Set the status of RADIUS servers
Enter system view
Create a RADIUS scheme
and enter its view
Use the command...
system-view
radius scheme
radius-scheme-name
server-type { extended |
standard }
To do...
system-view
radius scheme
radius-scheme-name
Chapter 1 AAA & RADIUS & HWTACACS
—
Required
By default, a RADIUS scheme
named system has already
been created in the system.
Optional
By default, the switch supports
the standard type of RADIUS
server. The type of RADIUS
server in the default RADIUS
scheme system is extended.
Use the command...
1-27
Configuration
Remarks
Remarks
—
Required
By default, a RADIUS
scheme named system
has already been created
in the system.