Displaying And Maintaining Rip Configuration; Rip Configuration Example - H3C S7500 Series Operation Manual

Operation Manual – Routing Protocol
H3C S7500 Series Ethernet Switches
To do...
Enter system view
Enter RIP view
Configure a RIP
neighbor

3.6 Displaying and Maintaining RIP Configuration

Display the current RIP running status
and configuration information
Display RIP routing information
Reset the system configuration
related to RIP

3.7 RIP Configuration Example

I. Network requirements
As shown in
Ethernet port. Switch A and Switch B are connected to networks 155.10.1.0 and
196.38.165.0 respectively through Ethernet ports. Switch C, Switch A and Switch B
are interconnected through Ethernet 110.11.2.0. It is required to configure RIP
correctly to ensure the interworking between the networks connected to Switch C,
Switch A and Switch B.
Use the command...
system-view
rip
peer ip-address
To do...
Figure 3-1, Switch C is connected to subnet 117.102.0.0 through an
3-12
Chapter 3 RIP Configuration
Remarks
—
—
Required
To make RIP works on a link that
does not support broadcast/multicast
packets, you must manually configure
the RIP neighbor.
Normally, RIP uses broadcast or
multicast addresses to send packets.
Use the command...
display rip
display rip routing
reset
Remarks
Available in any
view
Available in RIP
view