Configuring The Attributes For Data To Be Sent To Radius Servers - H3C S7500 Series Operation Manual

Operation Manual – AAA & RADIUS & HWTACACS & EAD
H3C S7500 Series Ethernet Switches
Set the status of the
primary RADIUS
authentication/authorizati
on server
Set the status of the
primary RADIUS
accounting server
Set the status of the
secondary RADIUS
authentication/authorizati
on server
Set the status of the
secondary RADIUS
accounting server

1.4.8 Configuring the Attributes for Data to be Sent to RADIUS Servers

Table 1-19 Configure the attributes for data to be sent to the RADIUS servers
Enter system view
Create a RADIUS scheme
and enter its view
Set the format of the user
names to be sent to
RADIUS servers
Set the units of measure
for data flows sent to
RADIUS servers
Set the source IP address
used by the switch to send
RADIUS packets
To do...
state primary
authentication { block |
active }
state primary
accounting { block |
active }
state secondary
authentication { block |
active }
state secondary
accounting { block |
active }
To do...
system-view
radius scheme
radius-scheme-name
user-name-format
{ with-domain |
without-domain }
data-flow-format data
{ byte | giga-byte |
kilo-byte | mega-byte }
packet { giga-packet |
kilo-packet | mega-
packet | one-packet }
RADIUS scheme view
nas-ip ip-address
System view
radius nas-ip ip-address
Chapter 1 AAA & RADIUS & HWTACACS
Use the command...
Use the command...
1-28
Configuration
Remarks
Optional
By default, all the RADIUS
servers in a customized
RADIUS scheme are in
the block state, and all
the RADIUS servers
configured with IP
addresses are in the
active state.
Remarks
—
Required
By default, a RADIUS
scheme named system
has already been created
in the system.
Optional
By default, the user
names sent from the
switch to RADIUS servers
carry ISP domain names.
Optional
By default, in a RADIUS
scheme, the unit of
measure for data is byte
and that for packets is
one-packet.
Optional
By default, no source IP
address is specified; and
the IP address of the
outbound interface is
used as the source IP
address.