Configuration Example; Configuring Queue Scheduling; Configuration Prerequisites; Configuration Procedure - H3C S7500 Series Operation Manual

Operation Manual – QoS
H3C S7500 Series Ethernet Switches
Note:
Only non-type-A LPUs support the traffic redirect configuration.
In a traffic redirect configuration, the source port and the destination port must be on
the same LPU.
The redirect configuration is effective only for ACL rules defined with the permit
keyword specified.
When packets are redirected to the CPU, they cannot be forwarded normally.

1.8.3 Configuration Example

A switch is connected to 10.1.1.1/24 network segment through its Ethernet 2/0/1
port.
Redirect all the traffic from the 10.1.1.1/24 network segment to GigabitEthernet
2/0/7.

Configuration procedure:

<H3C> system-view
[H3C] acl number 2000
[H3C-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[H3C-acl-basic-2000] quit
[H3C] interface GigabitEthernet2/0/1
[H3C-GigabitEthernet2/0/1] qos
[H3C-qosb-GigabitEthernet2/0/1]
interface GigabitEthernet 2/0/7

1.9 Configuring Queue Scheduling

Refer to

1.9.1 Configuration Prerequisites

The queue-scheduling algorithm is specified.
The ports that need this configuration are specified.
1.9.2 Configuration Procedure
Follow these steps to configure queue scheduling:
Enter system view
Enter Ethernet port
view
Queue Scheduling for the introduction to queue scheduling.
To do...
system-view
interface interface-type
interface-number
traffic-redirect
Use the command...
1-23
Chapter 1 QoS Configuration
inbound ip-group
Remarks
—
—
2000