Configuration Example; Configuring Rate Limiting On A Port; Configuration Prerequisites; Configuration Procedure - H3C S7500 Series Operation Manual

Operation Manual – QoS
H3C S7500 Series Ethernet Switches
Apply a rule in an IP ACL and a rule in
a link ACL at the same time
Note:
Priority marking configuration is effective only for ACL rules defined with the permit
keyword specified.

1.5.3 Configuration Example

A switch is connected to 10.1.1.1/24 network segment through its Ethernet 2/0/1
port.
Remark the DSCP precedence of the traffic from the 10.1.1.1/24 network segment
to 56.

Configuration procedure:

<H3C> system-view
[H3C] acl number 2000
[H3C-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[H3C-acl-basic-2000] quit
[H3C] interface Ethernet2/0/1
[H3C-Ethernet2/0/1] qos
[H3C-qoss-Ethernet2/0/1] traffic-priority inbound ip-group 2000 dscp 56

1.6 Configuring Rate Limiting on a Port

1.6.1 Configuration Prerequisites

The port where rate limiting is to be performed is determined.
The target rate is specified.
1.6.2 Configuration Procedure
Follow these steps to configure rate limit on a port:
Enter system view
Enter Ethernet port view
ACL combination
To do...
system-view
interface interface-type
interface-number
Form of the acl-rule argument
ip-group { acl-number | acl-name } rule
rule-id link-group { acl-number |
acl-name } rule rule-id
Use the command...
1-19
Chapter 1 QoS Configuration
Remarks
—
—