H3C S7500 Series Operation Manual page 67

Operation Manual – Login
H3C S7500 Series Ethernet Switches
Table 3-5 Determine the command level when users logging into switches are
authenticated in the password mode
Authentication
mode
Password
(authentication-
mode
password)
3.3.2 Configuration Example
I. Network requirements
Assume that you are a level 3 AUX user and want to perform the following configuration
for Telnet users logging into VTY 0:
Authenticate users logging into VTY 0 using the local password.
Set the local password to 123456 (in plain text).
Commands of level 2 are available to users logging into VTY 0.
Telnet protocol is supported.
The screen can contain up to 30 lines.
The history command buffer can contain up to 20 commands.
The timeout time of VTY 0 is 6 minutes.
II. Network diagram
RS-232
PC
Figure 3-2 Network diagram for Telnet configuration (with the authentication mode
being passw
III. Configuration procedure
# Enter system view.
<H3C> system-view
# Enter VTY 0 user interface view.
[H3C] user-interface vty 0
# Configure to authenticate users logging into VTY 0 using the local password.
[H3C-ui-vty0] authentication-mode password
Scenario
User type
VTY users
C onsole port
Configuration cable
ord)
Chapter 3 Logging in through Telnet
Command configuration
The user privilege level level
command is not executed
The user privilege level level
command is already executed
Switch
3-8
Command
level
Level 0
Determined
by the level
argument