Example: Configuring The Hybrid Port Shutdown Mode; Network Configuration; Software Versions Used; Procedures - H3C S12500R Series Configuration Examples

interface HundredGigE1/0/1
speed 10000
duplex full
dldp enable
#
interface HundredGigE1/0/2
speed 10000
duplex full
dldp enable
#
•
The configuration file for Device B is the same as Device A. (Details not shown.)
Example: Configuring the hybrid port
shutdown mode

Network configuration

As shown in
Configure DLDP to detect unidirectional links. When a unidirectional link is detected, DLDP
automatically shuts down the unidirectional port. The administrator needs to bring up the port after
clearing the fault.
Figure 5 Network diagram
Device A
HGE1/0/1
HGE1/0/2
Ethernet
fiber port

Software versions used

This configuration example was created and verified on Release 3606.

Procedures

1. Configure Device A:
# Enable DLDP globally.
<DeviceA> system-view
[DeviceA] dldp enable
# Configure HundredGigE 1/0/1 to operate in full duplex mode and at 10000 Mbps, and
enable DLDP on the port.
[DeviceA] interface hundredgige 1/0/1
[DeviceA-HundredGigE1/0/1] duplex full
[DeviceA-HundredGigE1/0/1] speed 10000
Figure 5, Device A and Device B are connected through two fiber pairs.
Tx end Rx end
Device B
HGE1/0/1
HGE1/0/2
Fiber link
12