Troubleshooting A Static Route - H3C S7500 Series Operation Manual

Hide thumbs Also See for S7500 Series:

Table of Contents

Operation Manual – Routing Protocol

H3C S7500 Series Ethernet Switches

[SwitchC] ip route-static 1.1.4.0 255.255.255.0 1.1.3.2

# Configure the default gateway of Host A to 1.1.5.1. Detailed configuration procedure

# Configure the default gateway of Host B to 1.1.4.1. Detailed configuration procedure

# Configure the default gateway of Host C to 1.1.1.1. Detailed configuration procedure

Now, all the hosts/switches in the figure can interconnect with each other.

2.5 Troubleshooting a Static Route

Symptom: The switch is not configured with a dynamic routing protocol. Both the

physical status and the link layer protocol status of an interface are UP, but IP packets

cannot be normally forwarded on the interface.

Solution: Perform the following procedure.

Use the display ip routing-table protocol static command to check that the

corresponding static route is correctly configured.

Use the display ip routing-table command to check that the static route is valid.

Chapter 2 Static Route Configuration

Table of Contents