Edge Node Configuration Example - H3C S7500 Series Operation Manual

Operation Mannual – RRPP
H3C S7500 Series Ethernet Switches
Display the brief
information of all RRPP
domains configured on
the switch
Display RRPP
configuration details on
the switch
Display the RRPP packet
statistics on the switch
To clear the RRPP statistics, use the reset rrpp statistics domain domain-id [ ring
ring-id ] command.
Caution:
The control VLAN of an RRPP domain cannot be a static VLAN already created on
the switch. If you configure a dynamic VLAN as the control VLAN of an RRPP
domain, the VLAN becomes a static VLAN automatically.
You are not recommended to configure a VLAN as both an RRPP control VLAN and
a remote-probe VLAN. (Refer to Mirroring part of this manual for information about
remote-probe VLAN.)
You are not recommended to configure a VLAN as both an RRPP control VLAN and
an isolate-user-VLAN/sub VLAN. (Refer to Extended VLAN Application part of this
manual for information about isolate-user-VLAN and sub VLAN.)
Before creating an RRPP ring, you need to create the control VLAN.
When deleting an RRPP domain by using the undo rrpp domain command, make
sure no RRPP ring exists in the RRPP domain.
The ring IDs of different rings in the same RRPP domain cannot be the same.

1.4.2 Edge Node Configuration Example

I. Network requirements
Define the switch as a node in RRPP domain 1.
Define VLAN 4092 as the control VLAN.
Define the switch as a transit node on primary ring 1 in RRPP domain 1,
GigabitEthernet 2/0/1 as the primary port, and GigabitEthernet 2/0/2 as the
secondary port.
To do... Use the command...
display rrpp brief
display rrpp verbose
domain domain-id [ ring
ring-id ]
display rrpp statistics
domain domain-id [ ring
ring-id ]
1-13
Chapter 1 RRPP Configuration
Remarks
Optional.
You can execute the
display command in any
view